Question Locked

LoopBack Interfaces in OSPF

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi ALl,

I learnt that loopback interfaces are always active and not associated to anykind of flippancies in Physical Interfaces on the router.

Can anyone explain me exact use of Loopback Interfaces in OSPF?

Thank You,
Srinivas

2 replies

by bfilmfan

For any OSPF process to initialize, it must be able to define a router ID for the entire OSPF process. Once the router-wide data structures are built, it is then necessary to define the networks that the router will advertise and the area numbers into which these networks will be advertised.

If no loopback interfaces are defined, the OSPF process uses the numerically highest IP address value on an active physical interface. If no physical interfaces are active and configured with an IP address, the OSPF code will not initialize. In recent IOS versions, the router issues an error message if it cannot find a router ID. Older versions simply do not initialize OSPF.

If there is only a single loopback interface, its IP address will always be the router ID.

This discussion is closed to new replies.