Discussion Locked

Losing connection to the AS400 system

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The school district where I work uses a web interface to connect to an AS400 system to store all school records. The system is located at the Intermediate Untit about 30 miles away. At least twice a day as the secretaries are entering data into the system they lose connection to the system and the data they were entering. We use another ISP provider for our internet and do not use the Intermediate Unit. Could the problem be that since we have to go through several routers (hops), because of timeout issues, is the reason we are losing our connection. When we lose the connection, we still have access the Internet. When we call the intermediate unit, they report that we are still connected and have to ask them to disconnect us so that we can sign on again. I am thinking about switching our ISP to The Intermediate Unit in hopes that this may reslove the problem. What do you think? What do you think is causing the problem? Should I switch the ISP provider?
My email is sbriotte@nycsd.k12.pa.us

Steve Briotte

3 replies

by tbradley

We currently run about 500 workstations connected to our AS/400 via Frame Relay, and last summer we experienced the same problem, although we use the IBM supplied Client Access for Win95/98. Even though our users at remote sites reported disconnects, the AS/400 reported them as still on-line.

The problem you have is in the router at the intermediate site. It is probably overloaded, and could use a memory upgrade. You need to ask whoever is in charge of the network at the intermediate unit to run tests to see what the router usage is at key points of the day, and if it exceeds 60% at any point, the router needs either reconfiguration, or more likely a memory upgrade.

OUr problems came around 8am, 11am, and 3pm, which coincided with the heaviest usage times.

Switching ISP's to the intermediate site would be an advantage, as it would speed up your access, yet without the router upgrade, you would still experience outages when the router bogs down.

I don't know what type of router they use, but chances are it is a cisco. If it is a 2500 series, they need to seriously look at a replacement, and keep the 2500 as a backup.

We replaced ours with a 3600 series, kept the 2500 in place and configured, although unplugged,and when we lost our 3600, it took us 2 minutes to get everyone back online. We operated at reduced capacity for 2 days until the 3600 was repaired and reconfigured, but that was 2 days of down time saved.

This discussion is closed to new replies.