Discussion Locked

LPT 1 is busy while trying to Print

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

HELLO ALL:

I am trying to print from a Dell Lattitude CS Laptop to an HP Officejet T Series Printer, and I get the following Similair message:

"Cannot print to HP Office Jet, the Port LPT 1 is busy. It may be in use by other applications. close all applications and try again."
The only applications open was MS Excel. I do have a feeling that there may be a problem with the Excel files my wife is trying to print; 4 linked documents loaded with MACROS (any thoughts on these?)

Now I tried the following:
Rebooted
Checked Pins on Serial Cable
Tried another Cable
Disabled Infrared Port on Laptop
Checked Device Manager for problems-Deleted LPT1. It reloaded on reboot.
Deleted and reloaded Driver
Checked ROM BIOS for any conflicts

Any Help is very much appreciated, as I am out of Ideas. this is a new printer and Laptop, both about one year old. the Laptop has 128MB RAM, running Windows 98.

TIA,

Jess

9 replies

by rwlap

Couple ideas based on information provided:
You mentioned "serial cable", when you typically would connect printer to the parallel port, not serial port. LPT1 is the parallel port and uses IRQ 7. On the particular Dell model you have, you can connect the floppy using the cable (provided by Dell-it is not a printer cable) to the parallel port so you can leave the cdrom in the bay and have access to both drives. Do you have the parallel port tied up with the floppy cable? Are you connecting the printer via parallel port? And are you using a printer cable to connect to laptop? HP software should allow you to test communication with the printer - have you tried that? One other possibility is to connect via USB if you particular printer model allows it. Hope this helps.

by rawright

I think rwlap has probably solved this for you, but just in case...

A few more things to check - verify that nothing else is sharing the port (scanner, for instance) as HPs don't seem to play nice with others. Verify in your BIOS setting that the port is an ECP port, and that Win98 acknowledges it as such. You should also be verify that the cable is a bi-directional cable - they all look the same, so it may be worth it to buy a new one to test with.

A first check I rely on a lot is to open a command prompt box, then type dir > lpt1 . If I get a humongous listing of the Windows directory I know that the hardware is not at fault (it usually isn't).

As a last resort, check with HP for a possible new driver. I wish you luck- I've never yet seen an HP printer that wasn't more trouble than its worth.

by ann777

I encountered this problem last week. There was a label printer using COM1 and it had a portion of the software configured into LPT1 as well. To resolve it:

Go into your computer BIOS ("Press F2 for setup") and reset the print mode to default (which in the newer computers is "Bidirectional"), save (In device manager, the LPT1 port should show as ECP). Let the system finish booting. Remove the printer driver software and reboot. Reinstall the printer driver from the setup program on the HP cd. Reboot and let the install finish. Everything should be fine now. Test print.

This discussion is closed to new replies.