Discussion Locked

mac address on a cisco 871

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi.

i just bought a cisco 871W, because i wanted to play with something along with my ccna studies BUT.

i got a ISP who has been given me a cable modem, and is giving me a specific ip address via DHCP, my problem is now, how do i see which MAC address my new router have, so i can tell my ISP about the new mac address??? i know i can type:
ip address dhcp client-id Ethernet 1
but still, i dont know what the mac address is, or can i change it somehow???

awaiting gladly for an answer :-)

/christian

7 replies

by michael kassner

You have to locate the 871 downstream of the cable modem. Its external interface would connect to the internal interface of the cable modem. That way the ISP does not even see the 871 and you can configure it as you wish.

by nicknielsen

Somewhere in the results of your ip address query, you should see a "Hardware Address" or "Physical Address." It will look something like this: 00 08 E3 1A 2B 3C.

To see an example, open a command window on your PC (Start | Run, type "cmd" and press enter). Then type "ipconfig /all" and press enter. On the third line of the results for this command, you will see a line titled "Physical Address" that is the MAC address for your network adapter.

And Michael K is correct. Connect your 871 between the modem and your system, not between your ISP and the modem. You will be able to play to your heart's content and the ISP doesn't even need to know.

Edit: grammar

by msn

well the problem is that my isp sees my "network" my setup right now:
i have a freebsd server with a network card connected to my cable modem, in order to get my ip address from my isp, they got my mac address of the netcard connected to the modem, so in order to get my correct ip address they need to know the mac address of the hardware connected to the modem. :-/

by michael kassner

So, you are saying that the ISP controls all of the IP addresses of the devices downstream of the modem? What is your routable IP address and the IP address of the server you have attached to it?

If the ISP controls the internal network IP addresses, I would definitely get a firewall/router in place to only allow them to see that device and no others. The firewall or router has the ability to NAT addresses for every other device downstream of it.

As for learning the MAC address of the router interfaces, you just get to use the command "show interface". This TechRepublic article explains the details and even how to spoof the MAC address of the external interface.

http://articles.techrepublic.com.com/5100-1035-6125413.html

by msn

Hi again.

well it works like this:

i buy a static ip from my isp.
they ask for my mac address.
when they see my mac address they give me my static ip address on that NIC via dhcp.
so atm i have my server with 2 ethernet card installed, one for outside getting ip via dhcp, and one for inside traffic to my lan, offcourse there is a firewall on this server too... but yes... with this setup, nothing is safe.. :-/ thats why i bought this router.

but thanks alot for the article that you posted that was the one i was looking for, then i can change the mac address of my router to the one my isp knows and then give me my ip address that i am paying for.

/christian

by michael kassner

That make sense now. The router will then allow you have as many downstream devices as you want. Just configure the router to act as a NAT device and it will appear that all of the traffic is coming from the router.

by asadullah1212

hello every one

i want to make secure my Cisco router 800/871 W and enable the mac address authentication any can help how to enable the mac address and how my mac it will support

Thanks
Assad

This discussion is closed to new replies.