Discussion Locked

Machine keeps resetting!!!!!!

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My machine keeps resetting!!! Its like i have pushed the reset button....one minute everything is ok next minute i am rebooting....is it possible a hardware component is bad?

12 replies

by dft3

You've got one of the following problems:

A shortage or bad connection with the reset wire of your chassis or maybe it is not securely connected to the motherboard.

Make sure all of the connections are okay. If they are and that problem persists, you may want to swap out the RAM chips. I've seen this problem before with RAM.

Finally, the power supply could be responding to fluctuations in the current of the outlet that it is plugged in to.

So, check your connections first, then the RAM, and then try another power supply.

Good Luck!

by dugandist

I had an Acer machine that done the same.After trobleshooting I found the power supply was on it's way out.

by wbutler188

it may be a few things,
either a power problem. power pack might be bad, is it in a house the pc? might be to much on a line. get an apc surge 7 arrestor. this will regualte teh power and prevent spikes. have you put an adapter on teh pc power cordnegating the ground?
also a component may not be seated. remove all cards and reseat them. this would cause this allso.
it could be abad component. remove ever card not needed, soundcard, network card etc, just leaving you with hopefully a video card. see IF this helps
also change your memory.memory may be bad too.

by cindycyn

I wouldn't even begin to offer solution w/o knowing.. OS? .. OEM? What have you done to the system lately? .. before this started?

by bv2

Depends - if your computer is doing a looping reboot, where everything boots up fine, then shuts down, reboots, loads everything, etc., there a couple of dlls that are corrupt. I don't remember which ones they are, but it's on MS Knowledge base

by bv2

Another thing you could try - just had a problem with a machine at work that used to work fine - started randomly shutting off - constant pressure on desktop from monitor eventually wore a cable through on a pinch point, and enough dust to start a landfill - blew out case, moved cables away from pinch points, reseated cards, voila! works like a champ now

This discussion is closed to new replies.