Discussion Locked

Making Capture Filters Network Monitor

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi ho,

I am trying to sniff out UDP ports 6001 & 6002 in a capture filter, and cannot seem to make a filter that will work well -- I can see all UDP traffic, but how does one narrow that filter to either or both of those ports?

Many thanks,
Dan

1 reply

by darthkim

If you have about 30 minutes, i would highly recommend using Ethereal, rather than the crappy network monitor from MS.

It is a sniffer, packet capture with tons of filtering capabilities, logging, etc.

and the best? its free... and runs on winXX.
www.ethereal.com

This discussion is closed to new replies.