5 replies
by acurrin
by dinovb
by brianaaa12
There may be other issues also. I don't know how your routers are set up, but I have found on Cisco routers, I have to configure "ip directed-broadcast" on ALL ports, Ethernet and Serial. Also, you may want to operate in bridged mode if you only have two sites. If you can ping the NT box, you may be able to map using Net Use command in a script.
Either way, it would be wise to install the Client for MS networks and setup a workgroup.
If the NT box is a domain controller, then tell the remote PC's log into an NT Domain and restore connections. In this case you will need to make sure your users and passwords are in sync between the netware and NT boxes.
brian
by dinovb
by dinovb
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending