Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Could someone please explain me how come that, when I connect with my PC to a remote server using VPN. I'm only able to map a drive when I use the server's name instead of the IP addres.
3 replies
by elmakrani Accepted solution
Clarifications
by lowlands Accepted solution
would be that when you use VPN you're using a NAT IP. the network is probably not set up to route internal ip addresses, but it does properly resolve the servername to a NAT ip.
What happens when you do a nslookup servername or a ping servername
by it Accepted solution
I have a smiliar problem. I can't browse to the server via its FQDN, but I can if I type in its IP address (which is the same on the LAN or over VPN).
Why not?
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies