Discussion Locked

Message to Users

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just taken over nt admin in my company.The former admin was not a fan of popup notice to users incase of intended server service or reboot.I want to setup a popup to info my users if I have to schedule a server service or reboot or any quickmessage that I want users to read asap.Do I need to have messenger setup before doing this and what are the draw backs to my network.My older colleague is afraid it will affect network traffic and he is not in support of this.I will also appreciate a direction on how to set this up.

15 replies

by rstencel

If you run winpopup on 95/98 client (put in startup folder) or messanger service on NT clients you can broadcast messages to the clients. Broadcast messages will have some effect on network performance, especially if you use switching technology asmessages will go to every colisson domain. The overall impact on your network will be minimal however unless your users start using netpopup to communicate themselves. I believe the benifits outway the potential problems unless you have unruly users.

by jypy

If you have NT SRV running as domain controller on your site, you can use the "SEND MESSAGE" in the first menu of Server Manager and selecting the servers on which you suppose there are users connected.

JP

by a.douwes

Have you checked out the NT's Net Send command? I think is also works on Win9x.
Start the command prompt and enter
net help send
to see the parameters. You can send messages to all users in the domain using the following command:
net send /domain:MY_DOMAIN "The message"
I would discurage you to use
net send /user "The Message"
for it takes too long to send the messages to the logged on users. The message is send seperately to each computer connected to the server.

by kay_lee

as long as you have the messenger service started on the clients (settings\control panel\services) started, i believe that messages will popup automatically when you use the NET SEND command.
only draw back is when you have print spooler services, every print job sent to a server shared printer, the sender receives a notification for every print job. this tends to be very annoying and i've been asked to remove this service from the workstation or server with the shared printer.
i've found itvery useful.
K.

by randelia

Yep, NET SEND is the way to go. If you don't have any slow WAN links to contend with, the /users option should still be pretty quick. If your WAN is huge or your network's bandwidth utilization is typically high, I'd stay away from NET SEND-ing a lot of users unless it's after hours and usage is low.

RE: Kay Lee's response about print notification messages. You can shut off the notifications for all printers on a server. Open up the printers folder on the server in question (browse or locally), choose File\Server Properties and go to the advanced tab. From there, uncheck 'Notify when remote documents are printed.'

by green lantern

Your past admin might not like popup messaging because it is not reliable. To use popup messaging the end user must have winpopup.exe running on their computer. You can broadcast all you want but they will never receive the message unless they arerunning a local winpopup.exe.

NET SEND or any other method used to send broadcast traffic to all stations will have no impact unless used. Therefore, no additional bandwidth will be used by running the messenger service except when you broadcasta message. Since it is a broadcast, there will be no acknowledgement message coming back so only the broadcst traffic will increase bandwidth for that finite amount of time it takes to send the message.

This discussion is closed to new replies.