Discussion Locked

Microsoft VPN RRAS Problem

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have setup MS RRAS and I have everything working fine, except for when my
clients disconnect from the VPN, the IP address the DHCP server hands out to
them thinks they are still connected with that IP address. That same server
is also running with WINS and is a Primary DNS server. If I ping the
machine by name, it brings back a 192.168.1.110 and then gives me a request
times out. The real IP should be 192.168.1.101. If I ping that address
then I get a reply back and everyone on the network can ping that address
also.

The clients machine is on our network, but I was using this as a test to see
how the VPN worked. I disconnected the machine from my network and used the
modem to dial into my ISP and then from there I dialedinto my VPN. Then
when I disconnect that is when I have the problem when I plug my client back
into the network.

I tried stopping and restarting my WINS service. I even went as far as
stopping DNS and DHCP. On the client I tried releasing my IP from my NIC
and renewing it. That didn't work either.

Anyone have any ideas? I did download and install the new Routing and
Remote Access Service from MS.

Let me give my configuration so that someone can maybe understand this better.
My Server:
IP is 192.168.1.2
Subnet mask 255.255.0.0
It is a Wins Server
It is a DNS server
It is a DHCP Server
Scope 192.168.1.100-192.168.1.199

Client:
IP when connected to Network 192.168.1.101 - it gets that from the DHCP server.
Subnet Mask 255.255.0.0
When disconnected from the network, IP can be any address in the pool.

Any help would be appreciated!

-Scott

3 replies

by burcjo

I had the same problem... Folks at company got off work, logged off their notebooks, flew home and couldn't get logged back into the network immediately.

How I wound up resolving that issue was to create a static pool of IP's on the RRAS server that would be assigned to the dial up machines. Then I enabled Microsoft DNS and created an entry for each of those IP's that was in the RRAS Server pool. This was a little extra work, but cleanly identifies all users who are connected via RRAS and was enough to allow everything to work correctly.

by smicale

So did you allow your clients then to make their own static addresses and tell the server that they were going to give an address rather then have the server assign them one?

by sburnett

I had nothing but trouble when my RRAS server was also running the WINS service. AS soon as i moved the Wins to another machine and unloaded it from the RRAS server all was fine.

This discussion is closed to new replies.