I would assume that the answer is yes? Note that there is more than one POE standard, and multiple 'modes' within each standard.
I would test the cable-run with a cable tester to verify that all eight wires have been properly punched-down at each end. It would be possible that the original installer simply installed the cable wrong.
POE is basically just running 30VDC over the wire, using the two unused pairs.
POE Specs:
"Mode A has two alternate configurations (MDI and MDI-X), using the same pairs but with different polarities. In mode A, pins 1 and 2 (pair #2 in T568B wiring) form one side of the 48 V DC, and pins 3 and 6 (pair #3 in T568B) form the other side. These are the same two pairs used for data transmission in 10BASE-T and 100BASE-TX, allowing the provision of both power and data over only two pairs in such networks. The free polarity allows PoE to accommodate for crossover cables, patch cables and auto-MDIX."
"In mode B, pins 4-5 (pair #1 in both T568A and T568B) form one side of the DC supply and pins 7-8 (pair #4 in both T568A and T568B) provide the return; these are the "spare" pairs in 10BASE-T and 100BASE-TX. Mode B, therefore, requires a 4-pair cable."
http://en.wikipedia.org/wiki/Power_over_Ethernet