Discussion Locked

Migrating from 10 MB to 100 MB TP

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are upgrading our network from 10 MB to 100 MP TP. The cable is suppose to be CAT5, (We live near China, so that name does not mean it is actual CAT5) and our longest leg is 30m. Our main hub is a 3com OfficeConnect 16 port. Legs run a maxium of30m in the building. We wanted to connect one 30m leg to a 3com OfficeConnect 8 port hub, but they refused to connect. I tried it on a shorter leg and it worked fine, and I put a 10 MB 8 port hub on that leg and it also worked. I have noticed thata few of our longer network cables don't work for the 100 MB connections, although they are CAT5. It has been suggest that I don't wire the cables straight, White-Orange, Orange, White-Green, Green, White-Brown, Brown, and White-Blue, Blue, starting on the right when looking at the bottom of the plug.
As for the answer, I am looking to 1) solve this problem, but two a better understanding of the differences in 10 MB and 100 MB requirements, wiring, etc. I have read 3com's tutorial and itdidn't help, and doesn't need to be repeated.

8 replies

by jmoden

The way that cat 5 cable is twisted it is important to use the proper color scheme and the wire and only be .5 inch from the casing.
the color code should be white-orange, orange-white, white-green, blue-white,white blue, white-green, white-brown and brown-white from left to right on the bottom of the plug..

by erothoff

Sorry for taking so long, but I wanted to test what you wrote. Changing the wiring like you had suggested has allowed at least two computers to work that had not earilier. I have not been able to test the Hub to Hub connections, but I believe that your solution will solve the problem. Thankyou

by @lberto

The differences between the 10 MB and 100MB is basicaly the speed. Your problem is probably your cables, try with a new cable, follow the right color codes (the previous answer explained very good).
If the hubs don't link to each other then try to use cross linked cable and it should make it.
Good luck,
@lberto

by erothoff

Sorry, but I had explained that I had read the manuals, I needed more information about the differences.

by Member 26122104

Merely using Category 5 cable is not good enough. 100Base-TX requires that the cables be Category 5 compliant, meaning you need to test them with a Category 5 cable tester and make sure they pass. These testers will tell you what the problem is ifthere is one.

by Member 26122104

Also, 3Com NIC cards don't work well with 3Com Hubs and switches. Especially the auto-negotiate for 10/100 and half/full duplex. You should set these manually.

by erothoff

I understand that if the Cable claims to be CAT 5 that it may not actually be CAT 5. I mentioned that possibility in my question.

This discussion is closed to new replies.