Discussion Locked

Modem found, but 'waits' to connect

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm running Red Hat 7.1 on a laptop with an internal modem. The dialup configuration tool detects the modem and I have set up the dialling properties correctly.

When I attempt to connect using the PPP dialer, it says 'WAITING TO CONNECT' with theprogress bar moving from left to right, until it eventually times out.

If I click the DEBUG button in the Internet Connections dialog box (where my dialup account shows correctly), a log window comes up where it dials and then attempts to connect.

How can I get it to work?

Many thanks,

Dan Falconar.

5 replies

by cascom

Sounds like your dialler is bypassing a link
to the modem that the debug utility finds.
Not uncommon.
Make sure that the link to your modem is correct.
If you know which com port your modem is
installed as, replace the /dev/modem entry in
the dialler configuration with /dev/ttySX,
where X is the number of the com port -1 (com
1 = /dev/ttyS0, com2 = /dev/ttyS1 etc)
This should allow the dialler to communicate
directly with the port and will remove at
least one hiccup.

by hypersoniq mcse

I have never worked with the hardware mentioned, but somewhere you should be able to enter a string to prep the modem (maybe in the ppp config script?)
try setting up the modem with a hard reset
AT command +++ (3 plus signs)
right before it configures with the normal AT... init string.

This discussion is closed to new replies.