Discussion Locked

Modem not detected/won't respond

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Windows will not detect a modem. I have looked at the modem. It is a conexant RS56-PCI. I have downloaded drivers and installed them manually. The modem still won't work. I have tried installing it on every available com port. I have removed the modem and the com ports from the device manager and let windows reinstall them. Still no modem. It was working before I formatted the hard drive today. Also only 2 com ports come up, and often only com1 is shown in device manager. It is an HP Pavilion 6605, Win98.

9 replies

by parbo

Go into the BIOS and make sure COM2 is disabled. If it is also disable COM1, Make sure the bios is set for Plug and play, save the settings and restart.
If it still doesnt detect it you might want to try the card in a different slot.

by shanghai sam

I have tried these suggestions and still have the same problem. Windows does detect a "PCI communications device" I guess that must be the modem?? however it won't install with any of the modem drivers.

by dmiles

Windows98 does not do a good job of detecting modems,load a generic modem driver on a floppy,select the modem and then proceed to manually install the modem,by selecting from list,then click have disk to install driver,after installing the modem,reboot computer and check the device manager to see if modem is present,if not reload the modem again by booting into safe mode and check to see if you have any modems listed,if so delete all but one and then reboot and install modem again,it takes a number of tries to get the modem installed using win98

by shanghai sam

I have already tried all this. I have even manually installed the correct driver, rather than a generic one. and I have certainly had a number of tries!

by grump

Go to device manager and check if there is any in the OTHER , if so remove it.
check ports in device manager and remove both or all comm ports..
In control panel double click modem and remove any found..
Shut down system and remove the modem fromthe computer.... Boot up you computer and let it find any comm ports and set them up..
Shut down you computer and boot it up a couple time with the modem sill OUT of the machine... After you have shut down and booted up couple times. with the computer power turned off, plug the modem back in but this time into a different PCI slot.. Turn on the computer ... If everything goes according to REDMOND you should see the new hardware found and a request for the dirver diskette... NOW THERE IS ALWAYSTHAT CHANCE THAT IN ALL THIS MARVEL THAT THE MODEM SIMPLY DECIDED TO QUIT....

You can not sucessfully install any drivers for a plug N play device {manually }...

by shanghai sam

I tried all that. Now...I think that the computer is actually detecting the modem (and has been all along). It detects a "PCI communications device". It must be the modem because the only other PCI device is the souncard (which I can't install either until I get the modem going because the files are too big for a floppy!). I can't install the communications device as a modem however. It doesn't accept the modem drivers. I don't know where to look for software that might solve this.

BTW could you please explain further your last comment re manual installation of PnP drivers? Thank a lot

by james.byrne

if a message coming up saying cannot use dial up networking no ppp protocol installed blah blah
right click IE and go to properties.
goto connections and make sure its not set up for LAN ie add a dummy connection (not ness ure ISP) then it should install DUN and your modem should work!

This discussion is closed to new replies.