Discussion Locked

Modem Troubles

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have this friend who uses win95 who can't get his
modem to connect. I went over, ran modem diagnostics
and it said that it "cannot communicate with modem,
make sure it is plugged in or turn it off". The phone
line is fine. I switched the modem to a different ISA
slot, same problem. There are no conficts in the
device manager. On the surface everything appears to
be fine. I unisntalled the modem and put in a known
working one and its still the same problem.
I uninstalled and reinstalled dialup networking.

Sometimes it will occasionally connect to the phone
line, sometimes it won't. It appears that after you
hang up, you have to wait a couple of minutes before
your able to connect again.

If anyone has any soutions to this problem I will
greatly appreciate it, because I'm frustrated to the
point of shunning technology and becoming amish. ; )

2 replies

by ong_matthew

There are a few possibility :-

1) Faulty modem .
2) Wrong Register timing for S7 & S9

If 1) nothing you can do about it.
If 2) Run a terminal session with the modem and change the settings.
S7 - wait time for carrier
S9 - Carrier Detect response time

by max

What com port is the modem on?
Try this, delete modem, add new hardware, select hardware from list, ports,communication port. Then re-boot. Re-install you modem and aim it at your new port.(you can do this in settings after you install the modem inthe wrong port)
You can keep on adding the same modem until it goes to the right port, then delete the modems that do not work, if it goes onto com2,try to get it to a different port. Com 1 and 3 use the same memory locations, same with com 2 and 4. You might have to adjust irq settings for the modem. Look at the modem, some have jumpers on them and will only use certain irq settings.
I had trouble with a modem that used com 2 and every time I disconnected I would have to re-boot to connect again, thats why it should be on a virtual port.
Sometimes in the bios you can force an irq for the slot your modem is in.

This discussion is closed to new replies.