Linux

Ask something
Discussion Locked

Monitor Total Control 1000 using MRTG

0 helpful
3 replies

by cjcknight

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How can I monitor the usage and performance of a Total Control 1000 using MRTG. The modules that I want to monitor are the 8 Hiper ARC Quad Modem modules.

thanks in advance

3 replies

by noorazam

MRTG is very configurable grapher, not just only for traffic.
If you need only monitor the traffic itself, you can just try to find the SNMP port of ethernet traffic. Try with cfgmaker community@ip.address.of.TC-1000.
You could monitor the modem pool also, but you have to understand snmpwalk command and a little bit of perl programming.
I use the MRTG to monitor a lot of stuff in my office.

This discussion is closed to new replies.