Discussion Locked

Mother Board Upgrade for NT4.0

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to upgrade my NT4.0 server mother board from 200mhz to 500mhz. What is the best way to do it or the right way to do it.
Any ideas will help. Thanks.

7 replies

by nohdowt

If you're going to just add a faster CPU, you don't have to change anything with NT.
However, if you're also changing the motherboard, I would reinstall NT because there may be new features the board has that an NT installation may only redetect since it's not a plug'n play OS. NT is picky about hardware changes.

Hope this helps...

by vue

I felt the same way. In fact, I did try it and the server didn't even boot. I was luck she didn't crashed on me.
Thanks....

by mckaytech

Changing a motherboard under NT only works if the motherboard chipsets are the same (or very similar).

The "right" way to do it is to back everything up to tape, change out the motherboard, re-install NT and your backup software and then restore from tape.

But quite often you can get away with a verified backup of everything up to tape (as a safety net), swap out the motherboard, and try to bring it up. If it comes up, cool.

If not, then you do a parallel installation of NT (i.e. intoa different directory from the original installation) and then move the hardware-dependent modules to the original installation directory.

Which one is the "best" answer depends on a lot of variables, such as the role of the server (PDC, BDC or member server), what special servers (Exchange, SQL, IIS) are running and what sort of data lives on the server.

paul

by itp

If this is a critcal Server don't do it Nt is hardware dependent the kernal will crash if it detects different hardware. Instead build a new box make it a the BDC and then restore all your data. When you know the new server is working down the PDCand promote the BDC. Change the server name to the same as the old server and dupicate the shares

This discussion is closed to new replies.