Question Locked

Motherboard will not power up with my psu but will with other psu

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I built my own computer about a year ago and everything was fine. A
week ago i found my computer had shut down and will not power up.
And when i hit power the fan moves and the led on motherboard
flashes but nothing after that. I've seen that others have had this
problem (fan 'twitches' and then nothing when hit pwr button) but
they found it was their psu. That is not the case here, i replaced my
psu (sent it in to newegg and they gave me a new one) and i still have
the same problem! I took it to a friends house and it worked
flawlessly off of his psu (550w) and still would not work on mine
(450w)
I think it might be a grounding issue but i cannot see any problems
unless i take everything out...is that what i need to do?
Any other suggestions?
My set up:

-rosewill psu (RD450)
-Biostar T-series motherboard
-AMD 6400 x2
-1 case fan

etc.
Please help, i need this comp. for school!

3 replies

by oh smeg

These need to be tested before being used and you can never buy [b]Too Good[/b] a PS.

I've been using Antec Power Supplies since they became available and have yet to have a single problem with one fail without reason.

Sure I've had several just not work from new and when this happens on a new build I just pull out a PS that is Known Good and test. Even the ATX PS Testers are no indication that the PS actually works properly. All they tell you is that the 5 Volt rail is working sort of right but may fall over when a load is placed on it.

Col

by seanferd

in case you are not testing *just the mobo*.

With everything else in your box, are the components drawing around 450W? That'll do it. Try testing with fewer components attached.

Test a different mobo on the supply. Or send it back again. Rosewill says they're all about customer satisfaction.

This discussion is closed to new replies.