Discussion Locked

mouse problem

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need help.I'm new with this stuff.My problem is that everytime I boot my computer to windows, I received the message saying "No mouse has been detedted....." I appreciate very much if you could help me.

10 replies

by ryan

1. First check the connection of the mouse to the ((correct port)) in the back of the computer!
2. Go to start/control panel/system/device manager and look under the mouse heading if that is not there then you will have to get the driver that should have been supplied with the computer especially if the mouse is not a microsoft compatible mouse.
3. Check to see that the mouse's cord is not bent or kinked badly.
4. Get another mouse and plug it in. If it works then it's the mouse.
5. Go into your BIOS and check if the mouse port is recognized. If not Turn it on.
Good Luck.

by xjpaulb

regarding your mouse poblem, the first thing i can suggest is to test your mouse with other computer if its works with other computer then the problem lies with your motherboard or other cable connector, if it doesnt then replace your mouse, probably it might work already.. if your mouse work with other computer then try checking your com ports there might be a loose connection between connectors and cable and also try replacing your serial mouse cable connector. but before opening your computer be sure you know what your doing otherwise you need a qualified technician to do the work.

good luck

by mckaytech

I think you've already received some excellent answers so I just wanted to add one small thought of something to check.

With some ATX motherboards with an embedded PS/2 mouse port, I have had this problem with a mouse attached to a serial port. Once I disable the PS/2 port in the BIOS, the problem goes away. Or if I switch to a PS/2 mouse.

Just something else to check....

good luck!

paul

by steve cody

I normally hate it when people chime in at the end when all good solutions have been presented. However, one thing was not mentioned.

If your mouse is PS/2, check the pins in the connector at the end of the mouse cable. Make sure none of them have become bent. If you attempt to insert the mouse and the cable is not oriented properly, you can bend the pins.
If the mouse is serial, check the connector on the PC. Those pins can become bent as well.
- Steve

by msillers

Once you've checked the other tips, if you find that the mouse still will not function, I've found that Windows will automatically detect non-microsoft mice and load a driver which appears appropriate. In my experience, this driver works for a whilethen you get the no mouse detected message or simply no mouse response. Try switching to the microsoft mouse driver. This seems to work well with any mouse I've tried. It's micorsoft mice that don't like other party drivers.

This discussion is closed to new replies.