Question Locked

moveing my server

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am moving my network, 6 PC and 1 server, 1 ROUER, 1 16 port switch. I'm moving to a new office. Can you till me how to setup the step by step to setting up at the office also I am add ONE new PC?

Can you till me if I have to Confidg the setting?

Will the IP address change?

can somfone help?

T! is installed at the new office.

BOB

3 replies

by oh smeg

At the new office. Then plug in the Router and hard wire a workstation directly to it to check the function of it.

The rest depends entirely on how the existing setup is configured. If everything goes through the Server you need to connect the server directly tot he router and then the remainder of the workstations to a Hub Connected to the second LAN Connection on the server.

If however the server is just a side note you connect the 16 port switch to the Router and then you connect the workstations & Server to the switch.

If there is a WiFi Network involved here you just need to connect the WiFi Access Point to the Router and then plug in the remaining computers.

As for adding another computer to the mix that depends on what you are using, how it is configured and where the Addresses are being handed out.

If you care to post back with complete Details of how the LAN is configured we may be able to help you but you really would be better off paying a professional to setup your system at the new premises.

Col

by rob miners

a pen and piece of paper and start drawing a map of the appliances and connections. Take note of what plugs in where. Trace the network cable and mark out where it terminates. Check it as you are dismantling and it will be easy to reconfigure.

This discussion is closed to new replies.