Discussion Locked

Moving Server/Comper with Static IP's

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have two locations connected through a T1 and two routers. I have the two location different subnets. I will be combining the two locations through a fiber so the routers are not necessary. I am concerned with the traffic of all of the systems on one subnet (about 200 systems total). What are some of my options.

9 replies

by mgonzales

Single Protocol TCP/IP

Run two WINS servers..this will help elimate broadcast. Make sure you set them up with a node type of P-NODE. This can be done by running DHCP. Make sure that you have all the required scope options for this network.

Also make sure your running a switch ethernet network. If your running hubs you will most likely have problems.

If you have any futher questions, please feel free to contact me directly.

Mike

by mckaytech

Subnetting is for addressing or security purposes and since you will only have 200 systems, one standard Class C subnet will work just fine with 50 or so addresses left over for future expansion.

The issue of traffic is really a separate issue and involves segmentation rather than subnetting. You will have at least two segments (one on each side of the fiber link) and if you have a switched environment (as opposed to hubs), you should have no trouble supporting 200 systems with decent response times.

paul

by umbral-echo

If you are using Windows machines you should disable the Server component on the client machines. This will eliminate the browser service broadcasts that will saturate your network. The result will be that those client machines do not appear in Network Neighborhood, but they are clients so there is little good reason to have them in there anyway. They will still be able to connect to the server machines normally.

To do this do not install File and Printer Sharing on the Windows 95/98/ME and the Windows 2000 Professional machines.

If the clients are Windows NT 4 Workstation clients you must unbind the "Server" service from the NICs to prevent the unnecessary traffic. This can be done from the "Bindings" tab of your network properties. This will also make it impossible to use the Windows NT 4 administration utilities to connect to those machines, but again, there is very little good reason to be able to if this network is already configured the way you want it to be.

The last alternative is to use the routers to segment the traffic, even though you don't need them to make your network work.

by nettek

If you are using standard hubs, you can replace them with switches. This will enable node A to communicate with node F without nodes B,C,D,E, etc. seeing any of the traffic.

This discussion is closed to new replies.