Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am segmenting my LAN in to 7-8VLANs, including VLAN 1 which hosts most of the servers and DHCP. I have tried to configure Cisco switches using "IP Helper-Address" & "IP DHCP Relay" commands but no success. Can someone share his experience with us to resolve this issue?
3 replies
by arshij Accepted solution
Clarifications
by sunu007 Accepted solution
1.use multiscpoe option in MS DHCP Server.
2.Create 7 or 8 scopes on the dhcp server with address pools like "192.168.1.0/24 ,192.168.2.0/24,....for each vlan.
3.create vlan interfaces on the router for each vlan, assign ip addresses and masks to the interfaces according to your DHCP scopes.
4.configre "ip healper address" on the router/L3 switch.
5. you are done.
by cg it Accepted solution
sunu is right, gotta have a layer 3 device [router] to "route" traffic between vlans
Cisco's term for this is "router on a stick"
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies