Discussion Locked

MS-DOS Compability file mode vs 32 bit

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Having a tough time getting rid of this MS-Dos file mode.(System-Performance Tab) How to I get it back to 32 bit file format.

Memory: 320 MB of RAM
System Resources: 85% free
Virtual Memory: MS-DOS compatibility mode
Disk Compression: Not installed
PC Cards (PCMCIA): No PCMCIA sockets installed
Compatibility mode paging reduces overall system performance.
Drive C: using MS-DOS compatibility mode file system
So my question is this: how do I get rid of it? Do I need to re-install windows? Or is it a matter of rooting something out?

I tried the following:
Found no NoIDE nor BAD-IDE under the HKEY_local registry
FDISk
scanreg/restore
updated most of all my drivers.
ect..

Don't know what else to do. Its affecting my PC'sperformance.

can anyone help.

PC Config:
GEForce2 MMx video card
16 gig HD
CD-ROM
CD-RW
ABIT motherboard
GenuineIntel x86 Family 6 Model 8 Stepping 3
320MB RAM
70% system resources free
Windows-managed swap file on drive C (7790MB free)
Available space on drive C: 7790MB of 12397MB (FAT32)

------------------

8 replies

by netuser

Go to your File System Properties and click the Troubleshooting tab. Uncheck any boxes that has a check mark. Then go to your Virtual Settings and let Windows manage your virtual settings. Restart your PC.

by matthew.manfredi

There was nothing clicked under the file system properties trouble shooting and the Virtyal Settings was set to Windows manage your virtual settings.
I did notice something in the hard disk controller.
I have a Intel 82371 AB/EB PCI BUS master IDE Controller and
Primary IDE controller (dual fifo)
Wasn't I suppose to have a secondary IDE Controller ???
Please help as this is driving me nuts ..

by matthew.manfredi

I've READ and tried and search ebverything that was suggested here.
Still no progress. My system is still under MS DOS compatilibity mode.
My last thing to do is to reinstall WIN98.
Can anyone tell me how easy that can be without me losing or corrupted my system.
I don't want to format my HD, just reinstalling overtop the existing O/S.
Can I just reinstall overtop and cause no harm ??
Please help ??

Thanks !!

by simon beck

Have you installed any old s/w, do you use any s/w designed for DOS.

You get this error when windows sees an old 16bit app using config.sys and/or autoexec.bat to deal with HDD requests.

If you have but don't need it, delete it along with config.sys and autoexec.bat.

If you dont have any old s/w you can still delete config.sys and autoexec.bat, windows doesn't need them and are only there for DOS compatability!

Regards

SB

by matthew.manfredi

Thanks !! SB for your input.
I've tried that as well and didn't make any differerence. (No old s/w, config and autoexec have been deleted)

Maybe I should reinstall WIN98 ??
Any other suggestions ??

This discussion is closed to new replies.