Multiple graphic adapters under NT4

Hi!

You cannot do this in NT4!

/Hasse

We have three computers running dual Matrox PCI graphics adaptors under Windows NT 4.0 Workstation on Compaq workstations. The graphic card manufacturer must provide drivers in order for this to work. They've been in production 24x7x365 for two years now with minimal problems.

The newer Matrox cards support up to four four PCI graphics adaptors, each controlling up to 4 monitors. Check out this URL for details: http://www.matrox.com/mga/products/g200_mm/mm_support.htm. Although I have not checked the marker recently, there were other vendors providing similar solutions.

Yes, NT can run multiple monitors. To save you the headache I had when attempting this, heed this advice. Even if the hardware manufacturer says the drivers are available for multiple monitor support, pay the extra dough and BUY A MULTIPLE PORT SINGLE CARD. They are available up to 4 ports i beleive, if not more. If it is all in one card, it installs so much easier. Trust me on this one. While they say it doesn't matter, i also recommend using the same model monitors for your setup. NT4 doesn'thave the ease of control that 98/2k has. using a multiple device card will save you a lot of headache.

Yes, NT can run multiple monitors. To save you the headache I had when attempting this, heed this advice. Even if the hardware manufacturer says the drivers are available for multiple monitor support, pay the extra dough and BUY A MULTIPLE PORT SINGLE CARD. They are available up to 4 ports i beleive, if not more. If it is all in one card, it installs so much easier. Trust me on this one. While they say it doesn't matter, i also recommend using the same model monitors for your setup. NT4 doesn'thave the ease of control that 98/2k has. use a multiple device card and save yourself a lot of time.

Yes, NT can run multiple monitors. To save you the headache I had when attempting this, heed this advice. Even if the hardware manufacturer says the drivers are available for multiple monitor support, pay the extra dough and BUY A MULTIPLE PORT SINGLE CARD. They are available up to 4 ports i beleive, if not more. If it is all in one card, it installs so much easier. Trust me on this one. While they say it doesn't matter, i also recommend using the same model monitors for your setup. NT4 doesn'thave the ease of control that 98/2k has. also, stick with pci cards if you go with single port cards, i've never been able to get agp cards working in this environment.

Yes you can use multiple cards in NT. I have used both Elsa sepperate boards and Appian Jeronimo Pro all in one boards and I prefer the Jeronimo boards because of the ease of installing. We use them in conjunction with MicroStation and have had no problems with them on about 8 PC's.
Bra-k