Question Locked

Multiple interfaces Same Gateway

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

There are two active network interfaces on our server machine running on Windows Server 2003. Both have same default gateway with DHCP enabled.

------------------------------------------------
Ethernet adapter Local Area Connection 4:

Connection-specific DNS Suffix . : ***.***.**
IP Address. . . . . . . . . . . : 10.109.56.11
Subnet Mask . . . . . . . . . . : 255.255.248.0
Default Gateway . . . . . . . . : 10.109.56.1

Ethernet adapter Local Area Connection 2:

Connection-specific DNS Suffix . : ***.***.**
IP Address. . . . . . . . . . . : 10.109.56.12
Subnet Mask . . . . . . . . . . : 255.255.248.0
Default Gateway . . . . . . . . : 10.109.56.1
-----------------------------------------------

Our network administrator says that setting same default gateway on both adapters is a bad practice. But when we remove default gateway on one of the adapters then it stops sending packets. Also, only one of the interface pulls the default gateway if not specified directly

Please help me in this regard.

Thanks in Advance

3 replies

by david.baines

The details provided indicate that both of these NICs are on the same IP Subnet (Range = 192.168.56.1 - 192.168.63.254).
In the routing table of the server, there would be a single entry saying that the route to 0.0.0.0 (ie, all foreign networks) is via your default gateway 10.109.56.1.

When you remove the default gateway from one of these NICS, I'm guessing that this entry now goes missing, as it's not normal to have 2x NICS attached to the same subnet as you have.

Why do you need 2x NICS on the same machine to be on the same subnet?

Dave

by simran

I need to have a seperate NIC for virtual machines so that disabling/enabling of the interface designated to Virtual Server wouldn't have any impact on other users

This discussion is closed to new replies.