Discussion Locked

multiple modem setup on NTWS4.0

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been trying to configure four internal modems(same brand & 56K)on NT workstation4.0 with out success.
I receive lot of error logs in the event viewer.This requirement is to receive faxes from four seperate telephone lines.
(I AM NOT MAKING MULTILINK TO INCRASE THE BAND WIDTH).
I followed all recommended steps to configure, but only the first modem is getting installed successfully.

If anybody knows this ,kindly reply please.

12 replies

by dc1

you are going to run out of physical resources (com ports and IRQ's) trying to do this. One alternative is look into a Digi card for your modem needs. WWW.DIGI.COM

by calves

You probably will be able to install 2 modems, 4 modems you'll need a digicard with 4 ports (+/- $1,000).

by vincent.ouwehand

If the computer in question needs these four modems, please disable (in your computers BIOS) those internal devices (like comm-ports and LPT-ports) that you do not use. After this you can configure each modem with a separate IRQ and mem address.After this the installation should become a lot easier.

Good luck,
Vincent Ouwehand
MCSE, The Netherlands

by robert.richards

You are not going to have enough system resources to handle four modems. You can theoretically have comm1 through comm4 but you have to share irq's 3 & 4 with comm1/comm3 and comm2/comm4 respectively so you can't use all four modems all the time. If you have to use four modems you need to get a multible modem board like digicom.

by jjenni_viper

each modem must have it's own irq. the way i did this same was to use a older motherboard with 3 isa slots. 3 isa jumper configurable modems,rec:3com isa pnp or creative labs 5601-1. turn off com1 and com2 in bios,jumper first isa board 3f8 irq4, boot into nt and run the modem wizard to install the driver. shut down and install second modem jumpered 2f8 irq3 boot winnt use modem wizard again install driver for modem 2,shut down and install third modem 3e8 irq5 boot in and run modem wizard install driver. you now have 3 modems all working on thier own irq. the 4th modem has to be a pci modem if on a pentium based pc and will be software configured to com4 irq 9 and then you have what you want.i did this to create a pc based modem bank and it works. cheaper than a digiboard or multiple modem card. the key here is that each modem must have it's own irq or nt will not be able to install them correctly.

This discussion is closed to new replies.