Discussion Locked

Multiple NIC redundancy

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello!

I am running Netware 4.11. I need to know how to use two NIC cards in a redundant setup. They are two different brand name NICs (not sure if it matters). But I need to have it use the same IP address and "share the load" and if one croaks, the other one just resume all the load. I am running IPX (802.2) as well as TCP/IP. Can anyone help?

Thanks!

15 replies

by mr_cellophane

It won't work. You can not have the same IP address on 2 NIC's anywhere on your network, let alone the same server.

by germain

Novell does not currently support IP load balancing (although you can do it with IPX). I have heard there is a third party application that will allow this, but I have not seen it. You can, however, multihome a NIC (i.e., assign two or more IP addresses to the same NIC, assuming they are on the same IP segment), but I don't know if this helps you. Novell has stated that there "engineers are looking into this".

by drdon

As a general rule, No, you cannot do what you are wanting at this time. That said, Compaq has a dual port (NC3131) NIC. Loading NFT,NLM from Compaq allows for the fail over portion. It does work well. The is a load balancing feature that allows to set one port to send/receive and the second port to rec with the fail over but that really does not accomplish what you are wanting.

by jpt

Try to look at Intel Etherexpress 100. You can set up two NIC's so if one goes down the other will take over with IP address. You have to load following in autoexec.ncf :

Load AFT.NLM ( before TCPIP.NLM )

Load both NIC's and bind just one( your primary), do not use Inetcfg.

AFT Balance Slotx Slotx

explanation: AFT stands for Adapter Fault Tolerance.

I am sure that Compaq have NIC's that will do the same.
John

by shaigh

As mentioned already the Intel cards can provide the AFT solution for you to make the 2 cards logically look like one. Be careful when configuring this to ensure that you overwrite the node bit and manually set the MAC address when you load the NIC driver so that your router/switch/workstations see the same MAC if one card fails.

by shaigh

As mentioned already the Intel cards can provide the AFT solution for you to make the 2 cards logically look like one. Be careful when configuring this to ensure that you overwrite the node bit and manually set the MAC address when you load the NIC driver so that your router/switch/workstations see the same MAC if one card fails.

by ben low

Try the Balance Suite from NSI Software. The web site is http://www.nsisoftware.com. Check out under the Network Utilities of the product section. Try out yourself on test machine before you deploy on live server.

This discussion is closed to new replies.