Discussion Locked

Multiple Novell Server Logins?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Novell 5.0 server and a Novell 4.11 server running. I have been trying to connect to both the servers with a Win95 workstation. I can access the 4.11 server with any Novell client below 3.0 and I can access the 5.0 server with the any Novell client above 3.0. The 4.11 protocal is IPX and the 5.0 is TCP/IP. Any suggestions would be appreciated.

5 replies

by dan_hammock

You should be able to connect to both server with Novell Client version 3.21. When you install the client chose custom and select IP and IPX.

by richard.mckinney

Check your frames! The most common problem with this type of setup is the FRAME TYPE. Check that the frame type on your servers and client match. You can check the frame types on the server by typeing CONFIG at a system prompt, or using INETCFG.My guess is that your pre-3.0 client is set to 802.2 and the server is on 802.3 or vice-versa.

This discussion is closed to new replies.