20 replies
by symo87 Accepted solution
by visualretailplus Accepted solution
by symo87 Accepted solution
by nickp2012 Accepted solution
by de.doughboy Accepted solution
by symo87 Accepted solution
by rob Accepted solution
Can you start your computer in safe mode? If so, then this could be a falty driver. If not then you have some kind of hardware issue. But I would try running a repair on the OS or a roll back of the OS. Have you installed any new drivers prior to your computer getting in the a reboot cycle?
Have you tried to run a rapair or roll back on your system? Press and hold the F8 key as your computer starts. You need to press F8 before the Windows logo appears. If the Windows logo appears, you will need to try again by waiting until the Windows logon prompt appears, and then shutting down and restarting your computer.
I hope this helps you and good luck
by symo87 Accepted solution
by pawandev Accepted solution
by de.doughboy Accepted solution
by symo87 Accepted solution
by de.doughboy Accepted solution
by symo87 Accepted solution
by hal 9000 Accepted solution
Just because the old one may appear to be working doesn't mean that it's working properly or producing the right voltages.
A slightly higher voltage on the 3 V Rail will cause the CPU to overheat and restart the system constantly.
I've had that problem with HP Power Supplies previously.
Col
by symo87 Accepted solution
by oh smeg Accepted solution
Yes the M'Board could be faulty ad if it is I would suspect the Power Supply has fried it.
Just because Fans Spin and lights work doesn't mean that the Power Supply is working it just means that it is supplying enough power to spin the fans and light the LED's, in the case of the LED's they can be lit from .5 of a volt to 12 volts with virtually no current.
by athamyr Accepted solution
Have you considered looking up the beep codes for the motherboard on the computer?
With the beep code, the motherboard itself would tell you what is wrong.
by springsscouter Accepted solution
Years ago when I worked at HP, I saw this on a server for one of our contracted support customers. We replaced virtually everything (video card, cable, motherboard, power supply, backplane) on the server, only and eventually (after weeks of troubleshooting) to find that the reset button was sticking, causing the server to constantly reboot. Check the reset button, on the case.
Gregg
by sn2112 Accepted solution
by davidfacer Accepted solution
Hi.
These problems are difficult to analyze, far less fix.
1. I suggest strongly that you try booting from a CD such as Hirens Boot CD. Success in this would point to an O/S issue. Then run the memory checker off the Hirens CD. So many puter issues start and end with bad RAM.
2. Should your situation not improve, I suggest - if you can - to access the BIOS and disable the SATA controller completely, then reboot again with the Hirens CD. The SATA HDD controller is the first firmware to load in the post process. If you gain a successful boot here you will need to replace the motherboard, or simply not be able to utilize SATA.
Best of luck!
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending