5 replies
by dramatizedthugster Accepted solution
by hal 9000 Accepted solution
And do a clean install from the Recovery Disc that at least will return the system to the As New State and then you can alter as required.
Col
by dramatizedthugster Accepted solution
by hal 9000 Accepted solution
You need to save all your data Wipe the HDD with a utility that writes zero's to every sector and then perform a clean install.
If the unit isn't working properly after that there is a Hardware Issue involved and nothing at all related to a software issue. So if you have a Floppy or are able to boot from a USB Device you can use Boot & Nuke available from here
Of if you have to boot from an Optical Drive the Ultimate Boot CD is available for download from here
Which needs to be downloaded burnt to a CD and then Booted off to run the wiping utility and then you can insert the Recovery CD to load Windows with and all the default software that came with the system new. When this is performed you should have the same setup as the unit was when new and no problems from any altered settings.
If you just reload the system it will not alter the settings and will just leave things that way that they where minus any Patches applied since the Slipstreamed CD was made. Even if you perform a Format over the system it will at best only write to every third sector and that is the Full Format if you use the Quick Option it will only alter the MBR's and leave everything else intact and capable of creeping through and affecting any new install.
Col
by dramatizedthugster Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending