Discussion Locked

Need Advice - 140m Ethernet Run Between Buildings

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hey community,

I'm facing a technical challenge and could really use your expertise. I need to establish a wired network connection between two points 140 meters apart - well beyond the standard 100m limit for Ethernet.

Key Details:

Outdoor installation (connecting two separate buildings)
Requires stable, reliable bandwidth
Must be wired (WiFi isn't suitable for this application)
Looking for real-world experience:

Has anyone successfully implemented a similar long-distance run?
What solutions actually worked in practice?
Any pitfalls or lessons learned I should know about?
I'm especially interested in hearing about what's worked (or failed) for others in field deployments.

Thanks in advance for sharing your knowledge!

PS: I'm aware fiber is an option, but curious about other approaches that might work with just rj45 cables.

3 replies

by rproffitt edited

1. Fiber. There are small ethernet to fiber boxes you put at each end.
2. Run it anyway. I've seen runs that far exceed the 100 meter on paper limit.
3. Put a switched hub powered by POE 50 meters out.

All this has been done before. Did you research this or are you looking for new magic?

by brainhayes75 edited

For a 140m Ethernet run between buildings, copper alone may not be reliable since it usually maxes out at 100m. The best option is fiber for speed, safety, and long-term use.

Link deleted as SPAM by moderator

by markpaul796 edited

standard cabling alone may lead to signal degradation. Here are some practical options:

Use Outdoor-Rated Cat6 or Cat6a Cable – Outdoor-rated cables are UV-resistant and often gel-filled to prevent moisture ingress. Cat6a can handle higher frequencies and may tolerate slightly longer runs.

Install a Network Switch or Media Converter Midway – Placing a small, weatherproof switch or Ethernet extender halfway can boost the signal and maintain full bandwidth.
Ethernet Extenders – There are specialized devices that allow Ethernet over longer distances on standard cables without switching to fiber.

Fiber Option (Recommended for Stability) – Even though you mentioned wanting RJ45, a short fiber run with media converters at each end ensures stable gigabit speeds over longer distances without worrying about signal loss.

This discussion is closed to new replies.