Need Tips please submit - ps/2 connector
What should I do?
1. Keep on buying MS Natural Keyboards we have bought 25 all ready.
2 Start finding ways on how to repair them.
Will soldering it incorrectly damage the PS2 ?
Peripheral
What should I do?
1. Keep on buying MS Natural Keyboards we have bought 25 all ready.
2 Start finding ways on how to repair them.
Will soldering it incorrectly damage the PS2 ?
by thechas
What is the specific problem you are having?
Are the PS/2 connectors breaking or falling apart?
If so, the first thing I would do would be to add extension cables, as the most likely root problem is that the users are pulling the keyboards and stressing the cables.
Alternately, the users may be setting the PCs too close to a wall and forcing the cables to bend too sharply.
Or, do you want to hard adapt a USB connection to a PS/2 plug?
The first question, is are the USB to PS/2 adapters straight through or active?
I have to admit that I have not checked if there are any active components in the USB to PS/2 adapters.
Still, I would play it save, and use a short PS/2 extension cable to move the doubled up connection away from the back of the PC.
Chas
by dbucyk
What you first need to determine is what type of solder they used in manufacturing of the board.
I think it is clear-flux solder but I may be wrong. It takes a very high temperature to melt that solder.
Be very careful though, at that temperature you have to make sure that you don't come in close range to other computer components because you will melt them.
Use a desoldering bulb to remove the solder and then take out the port.
However, if the bios is not emitting any beep codes or anything like that, then there is nothing wrong with the controller.
Check to see if anything is stuck in one of the pins.
A quick fix to that is to insert a thin metal pin all they way through it and push it out of the other end.
Hope this is of some help.
by igi_viraj
Hey open ur keyboard,check the color of wires soldered on the pcb,
c=clock
d=data
v=voltage
g=ground
Next go to wikipedia and check the config of a PS/2 keyboard connector,buy a PS/2 connector from an electronics shop and solder the wires as per the diagram/color codes,Bingo it should work.
This discussion is closed to new replies.
Sort by Trending