Discussion Locked

Netware 4.11 Time

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

I have a Netware 4.11 server that runs a login script to map drives, etc... Timesync also seems to be running, and everytime someone logs in, it changes there time to the server time. Which is fine...but the server is WRONG...(off by 5 mins slow) My question is...Can the clock on the server be changed via a command, or is it linked to the BIOS clock and I have to bring down the server to make this modification? Any suggestions would be greatly appreciated.

Thanks

3 replies

by acurrin

Use the set time command

If you type TIME at the console prompt and enter, it will display your current time.

then type in

SET TIME = 2:00:00 pm

for example, using the same format as is shown when you typed time.

If this server is the Single Reference Time Server, you are done. If it is not, you will need to make this change on the Single Reference Time Server.

This discussion is closed to new replies.