Discussion Locked

Netware 5.0 and Jet Admin

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am installing Netware 5.0 on a new Dell PowerEdge 4300 server. I can not get the HP jet admin cards in the printers to find the file server. I used Jet Admin 2.5 to set up the jet admin cards and rechecked all que names and print server names to make sure they are correct. The 4 jet admin cards worked fine on my old Compaq server using Novel 4.11. What am I doing wrong?

13 replies

by anthony.emery

We had a few HP printers that stopped communicating after we upgraded to NW 5.1. We discovered that the JetDirect firmware was pretty old. Once we updated the firmware, they began working again.

You may also want to consider migrating to NDPS. It integrates JetAdmin functionality into NWAdmin and works well with HP devices. It also makes driver distribution much easier.

by hcarlson

I have tried both ways as IPX/SPX and NDPS. One Jet direct is in a recently procured color printer. I would think it would have the latest Firmware.

by zubin.bharda

We also thought that since we had new printers we would have new Jetdirect firmware. But when we upgraded the firmware the printers started working. You might also see sometimes an error on the printer LCD panel indicating some kind of hardware error. The solution is to put the printer in its factory setting mode, then upgrade the firmware and then reconfigure the printer from Jetadmin. Good luck.

by robin

1. Try upgrading the firmware. Go to "http://www.hp.com/support/net_printing" for the instructions and latest version. You can also get a new version of JetAdmin from here.

2. If this doesn't work, try using the jetdirect cards along side pserver.nlm on the NetWare 5 server. If you are not sure about this, send me an e-mail!

Regards,

Robin

(robin@innocent.com)

by robin

1. Try upgrading the firmware. Go to "http://www.hp.com/support/net_printing" for the instructions and latest version. You can also get a new version of JetAdmin from here.

2. If this doesn't work, try using the jetdirect cards along side pserver.nlm on the NetWare 5 server. If you are not sure about this, send me an e-mail!

Regards,

Robin

(robin@innocent.com)

by rwscc

JetAdmin is dead. Version 3.43 was the last release. Get it while you can from HP's site. Now they provide WebJetAdmin, which may or may not work for you. Hp has also released a "Network Printer Installation Wizard." I really recommend it's use. It will setup each PC to print directly to the JetDirect using IP protocol. It eliminates all the nasty admin problems of print queues. Dealing with the user that just ran a volume out of space because they had no idea that a twenty page report withcolor bar charts would take a couple hundred meg when they set the print quality to maximum, enough to make you scream! But by using the HP network printer install the only thing that fills up is their one hard drive.

This discussion is closed to new replies.