Discussion Locked

Netware 5.1 & ArcserveIT 6.6 Loading

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having problems getting ArcserveIT 6.6 to run on my Netware 5.1 Server. The CSloader
hangs during the load of ASDB.NLM with a failed to load message. If I quit the CSloader and wait the system console says that the ASDB.NLM has loaded. Re running ASTART6 will then complete the process and ARCSERVE is loaded. The whole process takes about 30mins, and causes a slow down from which the serve does not recover unless it is rebooted. I have changed the version of NWASPI,CDM to v2.00 ay CAI's suggestion. Any ideas?

9 replies

by jon5

Database corruption may prevent the loading of the ASDB.NLM. Reference the following document:

http://support.cai.com/techbases/as61/10022.html#14

Another thing I have always used with Cheyenne's products is DELAYCMD. Put it last in the autoexec.ncf in use with launching ARCserve. ARCserve has problems loading if there are any other NLMs starting up, so this can help alot. You can find it at:

http://www.uiowa.edu/~itslan/lp/auto-ncf.html

Finally, you might try loading the latestNovell support pack:

http://support.novell.com/cgi-bin/search/tidfinder.cgi?2958182

Hope this helps.
Jon5

by acurrin

It could be database corruption. To check, stop ARCserveIT, backup the files under the ARCSERVE.6\DATABASE folder and then replace them with the contents of the EMPTYDB folder. Then restart ARCSERVEIT. If it works, stick with the new databases, you can merge old tape information into the DB as needed.

by meleager

I had trouble like this once, I downloaded the latest service pcks for netware and it didn't bother me anymore.

This discussion is closed to new replies.