Discussion Locked

Netware is not talking to my network

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Please help !!! My netware system crashed so I had to reboot. After rebooting none of the systems will talk to the Netware. I have no experience with netware and my netware specialist is on holiday.
can someone please help

7 replies

by ann777

After rebooting the NW server, you will need to reboot your client workstations. Basically, for your client computers to see the server that was rebooted, you need to re-establish their connection to the server.

Try it with one client computer.... it should be able to see the NW server and any other servers.

by mr_cellophane

At the Netware console type "Display Networks" this should give a list of numbers. This should show you that the server is seeing the network.

Another way is to type "load monitor" at the console. This should give you a blue screen with a list of numbers. There should be one "packets recieved"

by jimbb

If it crashed and rebooted, has it loaded the disk? Type "volumes", and see if there is at least a SYS:-volume. If there isn't you may need to run a repair using the VREPAIR utility: on the console type LOAD VREPAIR, select Repair a Volume, and follow the instructions on screen. You didn't say which NW version, and it does differ a bit.
Afterwards, restart the server:
NW4: DOWN followed by EXIT, reboot the machine
NW5: RESET SERVER

If you are sure there is a SYS: volume, you should have an autoexec.ncf file that executes some startup commands, including the onse for your network card. Type CONFIG at the console to see if a lan-card is loaded, and if the correct parameters are used (IP address, IPX address, frame types and so). If it says "no protocol is bound to this board", your card driver is loaded, but it doesn't use IP or IPX, so no communication is possible. Type LOAD INETCFG, and go through the "bindings" menu to correct things. It's a bit big to explain here, but it's not that tricky.

After exiting INETCFG, type "REINITIALIZE SYSTEM" to reload the LAN-drivers with your new parameters.

And once you have both a disk and a LAN-card properly set up, you should survive until your Novell Guru returns.

Jim

This discussion is closed to new replies.