Discussion Locked

Netware management with IBM Netview

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to manage 70 NetWare Servers in my company, and I have NetView instaled there. So, I want to manage it with netview. How can I do this?

5 replies

by Member 29244100

I'm not too sure about the capabilities of NetView, but I am sure you'll need the SNMP Agent installed on the Servers.

You'll need a
LOAD SNMP.NLM MONITOR=public CONTROL=private
somewhere in the startup.ncf, where the MONITOR= value is the Read Only Community String, and CONTROL= is the Read Write.

Then, I would imagine that it's just a question of adding the TCP/IP addresses of the servers to Netview (The Servers are running the TCP/IP Stack too, aren't they??) or let Netview discover the IPX Nodes. There should be a section somewhere for specifying the SNMP Community Strings to poll the servers with.

Hope this helps,

Jason.

by jimbb

I may be wrong here, but I don't think "just" loading SNMP is enough. It provides just the protocol, the path if you like, to transport traps, it doesn't provide any traps or information itself.
ManageWise does provide so-called "Management Agenst", and they are the guys that gather information and forward it via SNMP, I presume you need something similar for NetView. And then you need the necessary MIBs to "decode" that info and make it readable/graphical/whatever. I would presume IBM should be able to provide those kinds of things for your servers.

Good Luck

Jim

This discussion is closed to new replies.