Discussion Locked

Netwoking and sharing internet conection

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
There are 3 computers in my apartment. We have an internet connection (ADSL) through GTE. we want to network our computers and share the internet connection. Please help!

13 replies

by salexiev

Hello, in order to complete this task you must have router. You might bye some specialized device as ZyXEL Prestige 310/312 or to establish software routing/security/proxy ? you can try to use MS ICS (working on MS Windows 98 SE or Windows 2000) andone machine to act as gateway. Good luck.

by shiny_topadm

Hi, If you setup a peer-to-peer network and connect to the DSL modem with a router, I think you can get exactly what you have in mind. There is a great(!) piece of hardware, made by Linksys that is a Cable/DSL router and switch. This is designed exactly for this task. There are two models :BEFSR11 and BEFSR41, the only difference is the second one has 4 10/100 ethernet ports (which I think will do your job the best). Last week, the BEFSR41 was selling for about $179 on "www.cdw.com". More info is available on the manufacturer's site: "www.linksys.com". The only other thing you will need is network cards in each PC. It is possible to do this in software, too, using (Win98) internet connection sharing, but the hardware solution works better in a home setting...you can turn the PCs off, etc. and still have things work normally. you may email me if you have setup questions, but this isn't too hard. Linksys even has a "quick install" as part of their service offerings. good luck - Will

by fishchicken

One way is to connect the computers together using TCP/IP and an inexpensive Ethernet hub/NIC. Then on the machine conected to the DSL line you can use MS Internet Conection Sharing (Win 98se 2000) or get a proxy application (proxy+ is free at www.zdnet.com) There are full instrunctions on how to do this @ http://www.homepclan.com

by flan

if you have ics (win98se) use that at a proxy machine.

each machine needs to have 1 nic card, the machine with dsl needs 2. (you can purchase those nic D-Link combos where you get 2 nics and hub for like $60 or so)
use the tcp/ip protocols on all your computers, using a private networked address 192.168.xxx.xxx and use the proxy machine address as the gateway.

if you don't want to use ics (or don't have it) you don't need to buy a cisco router. just get either WINPROXY or SYGATE. Winproxy ($78) is so easy to set up, but cost twice as much as SYGATE ($30). Sygate is easy, but you need to know about computer a little. each gives you instructions how to set up the network.

by dmiles

Refer to the microsoft tech site to gather info on networking www.microsoft.com/tech/networking
The other part is you will need a to look up the networking using a dsl line for sharing.
NIC cards for 3 computers
A router
softwware for DSL line sharing

by timber

My DSL is setup to allow three computers to use it (It's a Cisco 675). You can plug it directly into the hub / switch with a standard patch cable not the one that came with your DSL Router (that's a crossover cable.) and all your pc's should then beable to access the internet.

This discussion is closed to new replies.