Discussion Locked

network boot floppy?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

one skill that has always eluded me is the ability to enter a novell network environment and create a boot floppy to connect a workstation to it. i have never found good documentation on how to do so. what are the steps, drivers and files needed to do so? is there a difference between booting to a 3.12 vs. 4.11 vs. 5.0 server? are there any good learning aids which can help me with this skill? i've always been jealous of experienced cna's and cne's that can do this.
thanks,
chuck

8 replies

by chazthespaz

the only network bootdisk on the website was a *.dsk file.....i have no clue what to do with this....

by erikdr

On the .dsk issue: there is a tool to read those images and put them on a diskette. Dunno the name.

However back to the more serious questions, because the website can be an invaluable know-how but still no know-why.

1. what are the steps,drivers and files needed to do so?
Basically the Novell client for DOS, which is still on their NetWare client CD and their website. With Client32 it is difficult to pack everything on one diskette, with the VLM client it is quite easy (altogether maybe 200 K).
2. is there a difference between booting to a 3.12 vs. 4.11 vs. 5.0 server?
Not as long as you use VLM client and install IPX on the 5.0 server also. Client32 has some difficulty with 3.12, but VLM has difficulty using an IP-only environment. Clearly the fate of coming from different generations.
3. are there any good learning aids which can help me with this skill?
Basically just the Novell client, and older books on NetWare which describe the DOS client in detail. That's the way we learned it anyhow...

Hope this helps,

/ The Netherlands

by it-sage (bschirf)

I *.DSK file is a disk image file. This is sorta like a ZIP file of the contents of the diskette, but where a ZIP file only contains the files themselves, a DSK file is an image of every bit on every sector of the diskette. Even bad sectors are included in the DSK image. (Note the 1.4MB size of the DSK file)

The MAKEDSKF and LOADDSKF are the old IBM utilities that respetively created the DSK files (MAKEDSKD) and then loaded the DSK file onto diskettes. (LOADDSKF)

You can find these utilities (or equivelent ones) at www.download.com, any other shareware site, or even download them from one of IBMs FTP sites.

So: Why create DSK files?

Once a diskette is made bootable, and all the needed files to care out some specific task are created... there needed to be some way of distributing the diskettes.

Once might first try to simply copy the needed files... but when idiots copy these onto a standard diskette, the diskette is not immediately bootable, and thus is unusable.

By creating DSK files of your imporant diskettes, you make it easy to distribute an entire diskette worth of executables and config files, all setup to carry out some task (like booting onto a Novell server) without making the person download 57 different files and having them place them in the right directories... oh yes... and remembering to make the diskette bootable first... and bootable with the specific version of DOS.

DSK files do all this for you. Very handy...

Check out a shareware site, download these utilities, and then re-visit that site again. In fact, that site probably had the needed utilities posted there also.

Good luck!

This discussion is closed to new replies.