Discussion Locked

Network Design

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
What device can combine the 2 DSL lines we have. One DSL is used for internet access. The other for FTP service from the outside. We would like the LAN to be connected to one box which in turn is connected to the 2 DSL routers from different providers. The reason bein, if one DSL goes down other one is available for internet access, without manually switching the cables. A box(router?) with NAT and firewall would be good.

15 replies

by c:\\>

Just stick in a box (linux, unix or NT) with 3 three network cards. Two towards the outside (for your two DSL lines) and one towards the inside, towrads your network. Then make sure you have the proper routes added on your box. And that should do it. You can use the sama box as a firewall too. In this case should be a linux or unix box. The access rules could be done with ipchains command. In this case you don't need a NATT machine.

by Former member

None of that's gonna work, Mr. Linux. Your clients only have one subnet, one gateway and if that gateway goes down, so do the clietns' internet access.

You need a router that first does the equivalent of HSRP (Hot Standby Routing Protocol), then you would put those two DSL connections on one of the Cisco routers and the internet connections via DSL will alternate and do a little load balancing, but overall if one goes down, the other will be used.

by vicmen23

I hope this can help you!

You can use a router (cisco 3620 would be best). Then use priority queueing. Prioritize http traffic on one port then ftp on another port. Traffic will be directed to the port it was assigned to. When one line "breaksdown" or "full", traffic or "some" of the traffic will be riderected to other line.

by vicmen23

I hope this can help you!

You can use a router (cisco 3620 would be best). Then use priority queueing. Prioritize http traffic on one port then ftp on another port. Traffic will be directed to the port it was assigned to. When one line "breaksdown" or "full", traffic or "some" of the traffic will be riderected to other line.

by harvey_pediman

The first gentleman was correct. You can put multiple NIC's in a box and make it act as a router. You can even set multiple gateways. You set your clients to point to the gateway box, and you set the gateway on the client side NIC to point to both DSL NIC's. Just assign the gateways with a priority so it goes out over the correct pipe.

You can also do this with a Cisco router, which generally is your best bet, as they are lower maintience and they tend to have less latency, but if you don't know IOS, you may need to bring somebody in to help, which can get costly fast.

by sprows

A good cheap solution would be a cisco 1605. Quite a bit cheaper than a 3620 and can handle two DSL's traffic just fine. Plug both DSL's into a hub and from there to one of the ports on the 1605. On that interface give it an address from each of the DSL's on the other interface give it an address from the rest of your LAN. then set a default route to each of your DSL's
ip route 0.0.0.0 0.0.0.0 x.x.x.x
ip route 0.0.0.0 0.0.0.0 y.y.y.y
the router will automatically load balance between the two and if one goes down it will still be able to use the other one.
The HSRP idea is also good, but my understanding was that it had to be running on the actual router and Cisco 675's don't do HSRP that I know of.
try that...see if it helps

This discussion is closed to new replies.