Discussion Locked

network neighbourhood not accessible

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
with 3 pc's connected on a p2p via a hub everthing is working fine.when pc's are switched off everything is lost.Although i can see pc's via find pc command , pc's are not aceessible.Please help

11 replies

by dubey_296

Hi
I think you look for properties of network neighbourhood .Is all the pcs have same workgroup define.I have also this type of problem but it got corrected when i chk my workgroup name

mail me you have more queries

by meganetcomputers

The first suggestion is usually a good solution for this problem but you may also run into policy problems if you have a 2k or XP box. What OS do you have on your boxes?

by avswamy

make it all in same work goup and configure all ip address are in same subnet.

it is better use one system as gateway to all systems so that your configuration may not be complex.
i hope this will solve your problem

by avswamy

some times it will happens when nic is installed properly, remove/uninstall from the system and shutdown the system and physically remove the nic and reboot see for any things in device manager, if every thing is properly then reboot and install thenic.

by quintar51

If you have any firewall software, try disabling it. I had a similar problem with zonealarm.

This discussion is closed to new replies.