Discussion Locked

Networked Printing So Slow!

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

With 5 PC's on a Windows 98 'shared connection' hub network, printing to the shared printers is so slow compared to direct printing.

Any settings, tweaks, or software add-ins I need to be aware of?

5 replies

by nichomach

Is it shared off one of the PCs or does it hang off a printer server?
What model printer is it? Are you using the full on drivers with bidirectional support, or just basic PCL/PS drivers?

by ericwi

Maybe u would try to change the speed of your network ie 100 to 10 mbps. Make sure the PCS are set to the same speed. Another thing u can do is to switch to another protocol.

by pkust

You say printing is slow. What about accessing file shares on the network?

Some things to check:
1. Are browser elections happening frequently? Five Win98 machines for the network means all the systems are approximately equal on the network--any one of them has the potential to be the master browser for the domain/workgroup. If browser elections are frequent, a lot of network traffic is being generated that doesn't serve an actual user task (i.e., print, file sharing, et cetera).

2.Are your NICs set to 100Mbs Full Duplex or 10Mbs half duplex? Unless a network card simply won't work on a full duplex setting, full duplex is generally preferable, as it allows better throughput.

3. If your network protocol is TCP/IP (likely but not mandatory in a Win98 network), is your subnet mask appropriate for the addresses being used? Most importantly, be sure you are not using the network or broadcast IP address (first and last address in an IP subnet, respectively) for any workstation--this will generate broadcast storms and other garbage traffic, and will slow network performance significantly.

Network printing in Windows 98 should not be that much slower than network printing, as a rule, even with default settings on the printer shares. Although the symptoms appear to focus on printing, I would tend to suspect network configuration more than I would the print sharing setup.

Hope this helps. Feel free to e-mail if your problem persists.

Cordially,

Peter Nayland Kust
TEKMedia Communications
pkust@tekmedia.com
http://www.tekmedia.com

by rmiller

extraneous network protocols loaded.... netbeui and ipx are killers on network performance.. try unloading any that you're not using.....

by neje

The network is obviously a Peer-to-Peer network. Since you do not require routing, it is good to use the NetBeui protocol as it is fast. In the print properties, click the advanced tab or where you have the rdio buttons to select spool or print directly..., select the print directly button and make sure the print spool is set to RAW. This should give faster print times.

This discussion is closed to new replies.