Windows Forum

Ask something
Discussion Locked

Networking

0 helpful
3 replies

by wayneinreno

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just purchased a new "Netgear" card and Cable. I put the card in, and when I plugged the cable into the Motorola Modem, It would not dial out. I can only assume that the drivers may not be installed properly. But, I went into the Devise Manager, and I located the card, clicked on advanced, then update drivers, rebooted, and it still is doing nothing. What am I missing here?
Thanks. I am attempting to have two computers run off the one connection. I am using Pipeline.

3 replies

by thechas

Hi Wayne,

When you setup your cable connection, it made use of the address assigned to the network card.

You need to tell the cable connection to use the new network card.

The simplest method would be to re-run the setup program from the cable company.

Chas

This discussion is closed to new replies.