2 replies
by a.c.simplina
There is a book on networking basics: Networking for Dummies by Doug Lowe ($19.99). Chapter 21 of this book discusses on how to network your home computers: network settings, sharing of disk drives and printers.
You can name your computers as SERVER01 and SERVER02 or whatever suits you. And the name of the Workgroup can be WORKGROUP.
The workgroup setup or peer-to-peer configuration is most suitable for home office networking.
You can bind the NIC (network adapter card) with the TCP/IPprotocol and configure the TCP/IP properties. Start -> Settings -> Control Panel -> Network. With the TCP/IP protocol bound to the NIC card, click on Properties and then click on [Specify and IP Address]. For the IP address, you can put 176.16.1.1 with subnet mask as 255.255.255.0. Repeat this procedure on the other computer with the IP address as 176.16.1.2 and subnet mask 255.255.255.0
I am assuming that you have Windows 95 or 98 computers and these are connected thru a hub with the patch cables.
Hope this helps.
by cpliam
Is it possible to network two PC without a hub?that is,having to PC connected by NIC with a twisted cable.
If this is not possible, is there any other solution?
choon Peng
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending