Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed the LinkSys Etherfast NIC on my server at work fine.I installed Linux at home with a P2-450.It finds the card. When I do a ifconfig it doesn't show and ifup gives me SIOCSFFLAGS: Resource temporarily unavailable and SIOCADDRT: network is down The light on my hub is also active.
6 replies
by mckaytech
I've used the Linksys NIC with both Linux and FreeBSD, and the problem you are having sounds like a driver issue.
If you're running a fairly recent Linux kernel, I believe the correct driver is the tulip.o driver (make sure you have a recent one). It goes in the conf.modules file without any parameters since it auto-probes for the needed information.
paul
by evan
by danielrivera
I am relatively new to the Unix world and my reply is not really meant as an answer but as a point to look at with your problem. When I was setting my OpenBSD box at home as a firewall using the same type of NIC you are using I encountered the SIOCSFFLAGS error on boot up. In my case it turned out to be that I did not properly configure the NIC. Sorry I could not be of much more help.
by evan
by jcmcintyre
Get the installation disk for the NIC, and copy the linux driver to /usr/src/linux/drivers/net. Recompile the kernel with the new driver, and you should be OK
by evan
This discussion is closed to new replies.
Trending Linux posts
Sort by Trending
0 helpful
7 replies
0 helpful
6 replies
Question Locked
RE: How to fix the Docker and UFW security flaw
0 helpful
3 replies
Discussion Locked
Which Linux works best on old phone or tablet?
0 helpful
5 replies
Discussion Locked
My Job and Company
0 helpful
3 replies