Discussion Locked
0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had a network with a crossover cable and now I went to put in a hub. The computers see themselves but they do not see each other. I am using linksys card NC100 and a linksys Hub NH1005. Can anyone help me. I emailed linksys but they have not replyed as of yet it's been two weeks.
12 replies
by dog170
Point value changed by question poster.
by ksmith
Are you still using the crossover cable? if you are that is your problem. Use a standard cat 5 cable.
Ken
by dog170
Poster rated this answer
by shmaltz
Dont use a crossover cable on a hub.
make sure you have installed the protocols that you want to use and that they are configured correctly.
by dog170
Poster rated this answer
by jpomposelli
Depending on the hub, you cannot use a crossover cable. Hubs generally have built in technology to do the crossover. Some hubs have a switch that allows you to use the cable by diabling the crossover circuitry.
by dog170
Poster rated this answer
I had a network with crossover cable and naw I went a new network. I am using isa card compatibil NE2000. I have 40 PC. I need a hub?
by dog170
Poster rated this answer
I had a network with crossover cable and naw I went a new network. I am using isa card compatibil NE2000. I have 40 PC. I need a hub?
by dog170
Poster rated this answer
by dog170
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies