Discussion Locked

New 10Gb hard drive only shows 16Mb!

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed a 10Gb hd on an older system due to a disk fault but when tryng to partition and format the disk from a 98 boot disk using Fdisk, the utilities can only see 16Mb.
After fomating and looking at the drive with Fdisk again, the partition shows as an FAT12 16 Mb active partition.(yes I said fat12) Any attempts to add extended partitions do not work as Fdisk say there is no more space.
The old failed disk was 2Gb and ran W95. Can any one help.

7 replies

by mm212

The bios won't handle anything larger than 2GB. You can solve this in a number of ways.

1. Use a drive overlay program such as OnTrack.

2. Put the drive in a newer computer to partition and format it. Once it is formatted, you can put it back in the old computer and it should work. I've done this myself.

Also, you will want to remove that old partition first, before creating any new partitions.

by tluong

The older BIOS does not support that high volume of hard drive there are two you can try.
1. Is to get a latest version of the BIOS from the BIOS Manufacture and update the BIOS.
2. You can use the ONTRACK Software but It will generate in lot of different portition.

by dread_aus

First off, remove the existing partitions you have put on.

Next download the latest BIOS updates for you motherboard.

Next got to the web site of the Hard Drive manufacturer and download some disk management software. Usually these will creat a boot disk for you and it will partition the drive out to its full length and let you install the OS.

Most times I don't bother with the BIOS flash as the disk managemnt software seems to kick in fine regardless of what bios says the hard drive is. But that could have been a result of a particular disk management software so it may not work all the time.

This discussion is closed to new replies.