new contrler raid on ntserver 4.0

First before you do anything, BACKUP your entire system and use verify to ensure a good backup. Second make sure you have a good current emergency repair disk. Third, make sure you address issues related to drivers for your new scsi controler. You be able to install the drivers before you shut down, you might have to utilize the three startup disks in order to put the drivers in, your manufacuture instructions should tell you how to perform this. Number four, break the mirror set through drive manager. Note which drive is drive 0. Install your new hardware raid controler. Select the drive you wish to mirror, drive 0. Then through the hardware utility, follow the instructions to mirror drive 0 with drive 1 and start your system.

This question was closed by the author