Discussion Locked

New PC built won't boot to windows

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

I built a new PC, third one I build. I am used to run into problems doing so, it is part of the fun. But here, I could need help.

Specs:
MB - ASUS TUF B850e wifi
CPU - Ryzen 7700
RAM- Corsair DDR5 6000 MHz
GPU - PNY RTX 5070
PSU - Corsair 850e

I put all this together and plugged it first without SSD to see if everything works.
Got to the BIOS.
I could see everything in the BIOS. CPU, RAM everything looks fine here, though RAM is showing 4800MHz...but that is not my main concern right now.
I went out and updated the BIOS. Restarted, changed the date and time in the BIOS.
Saved and exit.

then I took my SSD from my old computer and put it like it is thinking: " let's see if windows can handle this driver mess I am giving him". It worked on a previous computer. I just had to work on the drivers afterward but it worked.

Now, I can see the SSD in BIOS, but BIOS is telling me there is no boot device.
So I went to CSM and enabled it.
Save and exit
Motherboards leds go orange, red, white, green and then nothing.
Had to reset the bios via shortcut the CLRTC pins.

It worked, I am back to BIOS.
I tried the same but this time with "safe boot different OS".

Same result I had to shortcut the CLRTC pins to get back to BIOS.

I checked my partition on my SSD and it is GPT.

One last thing I haven't mentioned: I get no signal from the GPU (it is on, fans running) so I have to plug it on the MB, but I assume that is a driver problem, I might be wrong.
There is ofc the solution to just buy a new SSD and a clean windows install I guess.

Anyway at this stage any help is very much appreciated as I am quite stuck.

5 replies

by kees_b

- Boot into the BIOS and set it to default values.
- See if you can boot from Linux DVD or USB and all is fine there. If not, it's some hardware issue.
- Then do a clean install of Windows on an empty SSD (no partitions, just empty). Don't use the SSD of your old computer, unless you don't mind about what it currently contains or you have a very good backup.
- Then (if Windows doesn't) install a driver for the GPU.
- Then try again.

by Georges S

Thanks for the reply Kees_b,

The Linux solution is good I will try this so I can rule out (I hope) the hardware issue.
Empty SSD and Windows it will be.

I keep you updated.

thanks again

by rproffitt

"I checked my partition on my SSD and it is GPT."

I often find folk transplanting an old windows install or formatting a drive before installing Windows.

Spoiler: When I install Windows, I start with a single drive and it is blank. No partitions, nothing to see here, move along.

by Georges S

Thank you for the reply rproffitt,

I did it twice, it was bumpy but it worked.

Though I understand and you are right that the proper way is the one you describe.

by enterpriselaplink edited

Since your SSD is GPT, make sure CSM is disabled and boot mode is set to UEFI only in BIOS. Also, double-check that your SSD with Windows is listed first in the boot order.

For the no signal from GPU, try reseating the card, checking the PCIe power cables, and plugging your display into the GPU (not the motherboard) once BIOS recognizes it.

If it still won’t boot, a clean Windows install on a fresh SSD or after backing up your data is the most reliable fix — Windows doesn’t always like major hardware swaps.

This discussion is closed to new replies.