Discussion Locked

NIC will not take a DHCP address

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Running win2k with 3COM NIC and it will not take a DHCP address from my Linksys router. However I can assign a static IP address and it works fine. I was able to ping the NIC as well as take remote control of the PC using VNC. I have changed out the NIC and had different problems, like the NIC did not appear in the device manager. It is possible that the PCI slot is bad??? I am not sure, I tried different slots same problem.

3 replies

by josh

You may want to rebuild your TCP/IP firstly, you can do that with winsockfix...
http://www.eternalisp.com/patches/WinsockFix.exe

I would try a different port on your router and another cable. You may want to test the current cable as it is and see if there is a short or possible miswire (i have seen cables work even though the testing on them failed)...You may also want to check your NIC properties in device manager, and see if any settings are different from default. (example: force 10MB half duplex, force 100MB Full duplex, Auto Negotiate) Which of course in that exmpl you would want your setting to me AutoNegotiate.
Hope that helps, post back!

by stuchele

Josh, winsock fix did it. Thanks a million! Just so you know I did try a know good cable and different port in the router. Just was not sure how much space I had left on the orginal post.

This discussion is closed to new replies.